BMS_w160 — SW Brick Overcharged
Full alert identifier: BMS_w160_SW_Brick_Overcharged
Alert description
The battery management system (BMS) has detected that a brick is over-charged.
Potential impact
This alert is primarily informational and is used for logging purposes. It is intended to flag early overvoltage issues.
Set condition
The BMS detects that a brick voltage is over the maximum threshold.
Clear condition
The BMS detects that all brick voltage measurements are within the acceptable range.
Signals to check
Open this alert in Service Mode Plus and review the Payload tab. Use the field names below to identify the values shown by your vehicle.
| Signal | Unit |
|---|---|
D Vd Qmin
BMS_
|
V/brickAh |
Max Emp Val Per BMB
BMS_
|
V2/brickAh2 |
| Signal | Unit |
|---|---|
Is All Bricks In BMB Flagged
BMS_
|
— |
Max Brick Index Per BMB
BMS_
|
— |
Check other alerts
With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of BMS_w160.