Skip to content
Self-tests

Test Air Suspension Valve Block and Pressure Sensor Connection

Coriander/tasks/TEST-SELF_TAS_X_VALVE-BLOCK

Model S / X (2021+)

What this task does

Tests the electrical connection of the air suspension valve block reservoir valve, corner valves, and pressure sensor.

Vehicle compatibility

Select your vehicle’s hardware to see task details, requirements, and inputs. Availability is confirmed after connection.

Model S / X (2021+) AMD
Vehicle coverage
2021+ Model S, 2021+ Model X
Supported connection
Local connection
Vehicle state
Stationary · Parked
Gateway diagnostic level
DiagLinkActive, Factory, Service

Procedure notes

The air suspension valve block might be activated, which can cause the suspension to make noise.

Task inputs (0)

This task has no listed user inputs.

Related service tasks

Browse all tasks →
Communication checks

Air Suspension Chassis CAN Communication

Tests communication with the Air Suspension Chassis (TAS) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).

PING-TP_TAS

Model S / X (2021+)
Service procedures

Air Suspension Pressure Measurement

Measures the air pressure of the Tesla Air Suspension (TAS) system.

PROC_TAS_X_MEASURE-AIR-SUSPENSION-PRESSURE

Model S / X (legacy) Model S / X (2021+)
Service procedures

Calibrate Air Suspension

Calibrate the ride height of the Tesla Air Suspension (TAS).

PROC_TAS_X_CALIBRATE-RIDE-HEIGHT-PACK

Model S / X (2021+)
Service procedures

Check TAS Run Mode.

Check Tesla Air Suspension (TAS) Electronic Control Unit (ECU) mode.

PROC_TAS_X_CHECK-RUN-MODE

Model 3 / Y Model S / X (legacy) Model S / X (2021+)