Gen3/tasks/PING-TP_ESP
Tests the communication of the Electronic Stability Program (ESP) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the chassis Controller Area Network (CAN).
Select your vehicle’s hardware to see task details, requirements, and inputs. Availability is confirmed after connection.
When communication is established, the test will succeed. If the test fails, inspect wiring and ensure ECU is powered.
This task has no listed user inputs.
When communication is established, the test will succeed. If the test fails, inspect wiring and ensure ECU is powered.
This task has no listed user inputs.
When communication is established, the test will succeed. If the test fails, inspect wiring and ensure ECU is powered.
This task has no listed user inputs.
Clears Diagnostic Trouble Codes (DTC) in the Electronic Stability Program (ESP) Electronic Control Unit (ECU).
PROC_ESP_X_CLEAR-DTCS
Tests the communication of the Electronic Stability Program (ESP) Electronic Control Unit (ECU). Communication is established over the Party Controller Area Network (CAN).
PING-DTC_ESP_X_PARTY
Resets the Electronic Stability Program (ESP) Electronic Control Unit (ECU). Reset is executed via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
TEST-RESET_ESP
The Electronic Stability Program (ESP) Hydraulic Control Unit executes the brake fluid flush and bleed process. Active-circuit wheels are Front-Left (FL) and Rear-Right (RR). Use this routine only during fluid flush or bleed with appropriate brake bleeding equipment. The estimated time to complete is five seconds. The ESP Hydraulic Control Unit will run the high pressure pump and control circuit valves to facilitate a prescheduled brake fluid flush or bleed.
PROC_ESP_FRONT-L-REAR-R-BRAKE-BLEED