Gen3/tasks/PROC_HVC_X_PACK-REPLACEMENT
Before running this routine, a Controller Area Network (CAN) Electronic Control Unit (ECU) redeploy needs to pass. After a High Voltage (HV) Battery replacement, this routine runs all required tasks.
Select your vehicle’s hardware to see task details, requirements, and inputs. Availability is confirmed after connection.
Pack contactors may close or open.
This task has no listed user inputs.
Pack contactors may close or open.
This task has no listed user inputs.
Pack contactors may close or open.
This task has no listed user inputs.
Clears the HVC battery coolant flood alert, BMS_a124_Battery_Coolant_Flood, if set. This routine shall only be executed after repairing the HV battery isolation issue.
PROC_HVC_X_CLEAR-BATTERY-COOLANT-FLOOD-ALERT
Clears the HVC internal isolation alert, BMS_a123_SW_Internal_Isolation, if set. This routine shall only be executed after repairing the HV battery isolation issue.
PROC_HVC_X_CLEAR-INTERNAL-ISOLATION-ALERT
Clears the High Voltage Controller (HVC) isolation counters and alerts BMS_a027_SW_Repeated_Isolation_Failure_In_Drive, BMS_a172_SW_Isolation_Failure_In_Drive_Warning, BMS_a123_SW_Internal_Isolation, and BMS_a124_Battery_Coolant_Flood, if set. This routine shall only be executed after repairing a HV system component for loss of isolation.
PROC_HVC_X_CLEAR-ISOLATION-CONDITION
Clears the HVC SOC1 snapshot which in effect clears all HV battery brick weak short calculations and BMS_a029_dSoc_Limiting, if set. This routine shall only be executed after installing a new/remanufactured HV battery.
PROC_HVC_X_CLEAR-SOC1-SNAPSHOT