Service procedures
Clear Post-Crash Load Shedding
Clears the load shedding from the Vehicle Controller.
PROC_VCBATT2_X_CLEAR-POST-CRASH-LOADSHEDDING
Model 3 / Y
Reset Frunk Latch Sensing Degraded Metric
Gen3/tasks/PROC_VCBATT2_X_RESET-FRUNK-OPEN-FAIL-METRIC
What this task does
This routine resets the frunk latch open failure metric alert. Note that the frunk latch open failure metric is only active on single release actuator vehicles.
Vehicle compatibility
Select your vehicle’s hardware to see task details, requirements, and inputs. Availability is confirmed after connection.
Model 3 / Y AMD
- Vehicle coverage
- 2024+ Model 3, 2025+ Model Y
- Supported connection
- Local connection
- Vehicle state
- Stationary · Parked
- Gateway diagnostic level
- No specific level listed
Procedure notes
This routine should only be run once the latch has been thoroughly inspected/replaced. Confirm latch is properly reporting open when physically open and switches are not damaged.
Task inputs (1)
confirm
confirm · Bool
VCBATT2 frunk sensor degraded metric will be reset. Make sure frunk latch has been inspected/replaced before running it.
Default: false
Related service tasks
Browse all tasks →
Service procedures
Clear right headlamp latched faults in factory
Clear all right headlamp factory latched faults that were triggering rightHeadlampFactoryFault alert
PROC_VCBATT2_X_CLEAR-HEADLAMP-LATCHED-FACTORY-FAULTS
Model 3 / Y
Communication checks
Front Vehicle Controller (VCBATT) CAN Communication
Tests communication with the front vehicle controller (VCBATT2) Electronic Control Unit (ECU). Communication is established via Unified Diagnostics Services (UDS) over the Controller Area Network (CAN).
PING-TP_VCBATT2
Model 3 / Y
Self-tests
Frunk Emergency Release Switch LED Connection
Checks the electrical connection of the LED light in front trunk emergency release switch controlled by the Front Battery Controller (VCBATT2).
TEST-SELF_VCBATT2_X_FRUNK-LED
Model 3 / Y