Skip to content

BMS_f011 — HW Illegal Ctr Req

Full alert identifier: BMS_f011_HW_Illegal_Ctr_Req

Message shown in the car

Unable to start vehicle Service is required

Alert description

The battery management system (BMS) detects that there are system faults and prevents the pack contactors from closing.

Potential impact

Inability to charge, drive, or support the low voltage (LV) system

Set condition

The complex programmable logic device (CPLD) detects a condition that prevents pack contactors from closing. Alert log signal data provides information on the specific condition(s) detected

Clear condition

The CPLD detects that the condition clears.

Signals to check

These diagnostic fields are associated with BMS_f011. Check the alert's Payload in Service Mode Plus for available values.

Signal Unit
Blind Mate Fault BMS_a011_blindMateFault —
Bmb Fault BMS_a011_bmbFault —
Bmb Fault Diag Down BMS_a011_bmbFaultDiagDown —
Bmb Fault Diag Up BMS_a011_bmbFaultDiagUp —
Cont Hold BMS_a011_contHold —
Cont Hold Timeout BMS_a011_contHoldTimeout —
Cont Safety Override BMS_a011_contSafetyOverride —
Contactor Power Req BMS_a011_contactorPowerReq —
Show 21 more fields
Signal Unit
Contactor Prw Seq Err BMS_a011_contactorPrwSeqErr —
Contactor State BMS_a011_contactorState —
Contactors On BMS_a011_contactorsOn —
Crc Error BMS_a011_crcError —
Fast Kill Activated BMS_a011_fastKillActivated —
Fch Cont Pwr Ovr Current BMS_a011_fchContPwrOvrCurrent —
Fch Power On BMS_a011_fchPowerOn —
Hvil Bad BMS_a011_hvilBad —
Hvil Fault BMS_a011_hvilFault —
Illegal Cont Req BMS_a011_illegalContReq —
Illegal Sleep Req BMS_a011_illegalSleepReq —
Key On BMS_a011_keyOn —
Mcs Over Current BMS_a011_mcsOverCurrent —
Over Current BMS_a011_overCurrent —
Over Current Diag BMS_a011_overCurrentDiag —
Over Voltage BMS_a011_overVoltage —
Over Voltage Diag BMS_a011_overVoltageDiag —
Precharge OK BMS_a011_prechargeOK —
Sleep Timer Cal BMS_a011_sleepTimerCal —
Timer Alarm BMS_a011_timerAlarm —
Veh Can Bus Active BMS_a011_vehCanBusActive —

Check other alerts

With Service Mode Plus enabled, open Service Alerts → All. Review the other alerts for clues to the cause of BMS_f011.

Browse all BMS alert codes