Gen3/tasks/PROC_X_COMPRESSOR-RPM-OVERRIDE
Set the compressor to a target speed (800-7000 RPM). If sweep is disabled, the compressor will ramp to target RPM and hold that speed for 15 seconds. If sweep is enabled, the compressor will ramp to target RPM in 500 RPM increments and hold at final target RPM for 15 seconds. Note: The routine may skip some RPM values during sweep, or stop short of the target RPM. This is because some vehicles have certain speeds that are avoided.
Select your vehicle’s hardware to see task details, requirements, and inputs. Availability is confirmed after connection.
The compressor will operate at high RPMs. To prevent potential damage, ensure the thermal system is fully functional before running this routine. Pumps will run at moderate speed.
target_rpm · Int
Enter the target compressor speed (800-7000 RPM).
Default: Not specified
enable_sweep · Bool
Sweep to RPM target in 500 RPM increments.
Default: false
The compressor will operate at high RPMs. To prevent potential damage, ensure the thermal system is fully functional before running this routine. Pumps will run at moderate speed.
target_rpm · Int
Enter the target compressor speed (800-7000 RPM).
Default: Not specified
enable_sweep · Bool
Sweep to RPM target in 500 RPM increments.
Default: false
The compressor will operate at high RPMs. To prevent potential damage, ensure the thermal system is fully functional before running this routine. Pumps will run at moderate speed.
target_rpm · Int
Enter the target compressor speed (800-7000 RPM).
Default: Not specified
enable_sweep · Bool
Sweep to RPM target in 500 RPM increments.
Default: false
Clears the diagnostic data on the chosen Electronic Control Unit (ECU). This will clear any active Diagnostic Trouble Codes (DTC). DTC functionality may not exist on all ECUs depending on the platform.
PROC_X_CLEAR-DTCS
Clear the Mando Decoupled Brake (IDB) Diagnostic Trouble Codes (DTC).
PROC-IDB_X_CLEAR_DTCS
Clear the Mando Redundant HCU (RCU) Diagnostic Trouble Codes (DTC).
PROC-RCU_X_CLEAR_DTCS
Executes a routine to clear the side view mirror fold actuator type auto-detected by the Tesla ECU.
PROC_X_CLEAR-MIRROR-FOLD-TYPE