Skip to content
Diagnostic tests

BMP Watchdog Enabled Check

Gen3/tasks/TEST_GTW_BMP-WATCHDOG-ENABLED

Model 3 / YModel S / X (2021+)

What this task does

This check succeeds if the gateway reports that the bmp watchog is enabled.

Vehicle compatibility

Select your vehicle’s hardware to see task details, requirements, and inputs. Availability is confirmed after connection.

Model 3 / Y AMD
Vehicle coverage
2024+ Model 3, 2025+ Model Y, Model Y, Pre-2024 Model 3
Supported connection
Local connection
Vehicle state
Stationary · Parked
Gateway diagnostic level
No specific level listed

Task inputs (0)

This task has no listed user inputs.

Model 3 / Y Intel
Vehicle coverage
Model Y, Pre-2024 Model 3
Supported connection
Local connection
Vehicle state
Stationary · Parked
Gateway diagnostic level
No specific level listed

Task inputs (0)

This task has no listed user inputs.

Model S / X (2021+) AMD
Vehicle coverage
2021+ Model S, 2021+ Model X
Supported connection
Local connection
Vehicle state
Stationary · Parked
Gateway diagnostic level
No specific level listed

Task inputs (0)

This task has no listed user inputs.

Related service tasks

Browse all tasks →
Diagnostic tests

Enable BMP Watchdog

This network enables the BMP watchdog and exits with 0 if it was enabled successfully

TEST_GTW_ENABLE-BMP-WATCHDOG

Model 3 / Y Model S / X (2021+)
Service procedures

Steering Wheel/Yoke Vehicle - Set Configuration

Run this routine after retrofitting the wheel type in any manner. Sets the steering wheel configuration based on the installed part number. Note: Model S/X Long Range built after 8 MAY 2025 do not support yoke; only ROUND or ROUND_MECHANICAL_HORN selections are accepted on those vehicles. Plaid variants are unaffected.

PROC_GTW_X_STEERING-WHEEL-YOKE-SWAP

Model S / X (2021+)